https://www.youtube.com/watch?v=o1rLEAjACz8

This topic is VERY touchy as it is border-lining with paranoia. MUCH MORE AND PRECISE TESTS ARE NEEDED TO PROVE IT REALLY EXISTS. Proving it could be extremely hard and very expensive.

Using a hundred or even a thousand dollar scanner or bug detector is not going to give an accurate result and positive identification. It MIGHT indicate that THERE IS SOMETHING but nothing more.

Whatever that cheap device detects was MEANT to be detected but THERE ARE MORE if you find one.

Some suggestions below, that CAN BE done by anybody with relatively little cost. IF, you suspect you have some kind of man-made electronic implant, build this little hand held device.

Get a VERY, VERY strong neodymium permanent magnet, preferably a big straight rod but with some ingenuity on your part, you could use ANY shape magnet. The main thing is, the magnet HAS TO BE STRONG.

Get a small electric motor and figure out a way to mount that magnet on the motor's shaft. The higher the motor RPM the better. Some magnets have holes at the center, so that would be relatively easy to mount on the motor's shaft.

When you are finished building it, turn on the motor, hold it in your hand and scan your entire body very slowly. Make sure, the rotating North/South poles are as close to your skin as possible as the motor rotates the magnet. You might need a worm gear drive motor, like an angle grinder (NOT as big) to get the rotating magnet to your skin as close as possible.

What will this device do?
The rotating magnet will induce voltages in the conductors of the implant. IF, the induced voltage is high enough, it will destroy all the P/N junctions by breaking down the “barrier region” in the semiconductor. In plain language, it will short out the semiconductor wafer the chip is built on. Essentially, this device is a miniature EMP gadget.

The STRENGTH of the magnet, the SPEED how fast it rotates and the DISTANCE are CRITICAL to work properly and induce a high enough voltage to punch through the “barrier region” of the P/N junction.

Another way is if you make or find a coil, you can “pump” some serious current and high voltage through it then hook it up to a high power pulsating circuit and scan your body with that coil.

If you use - preferably laminated iron core in this setup and the above setup - the iron core will extends the magnetic field somewhat. The distance and strength of the magnetic field are inversely proportional and exponential. If you increase the distance of the coil or permanent magnet from your skin, the magnetic field weakens exponentially.

BE CAREFUL WITH ALL OF THESE DEVICES AS STRONG MAGNETIC FIELDS EFFECT BODY FUNCTIONS. SHOULDN'T USE IT AROUND YOUR HEART AND DON'T START SCANNING YOUR HEAD WITH THE MAGNET OR ELECTROMAGNET CLOSE TO IT. START YOUR SCAN A COUPLE OF FEET AWAY.

IF, YOU HAVE A MAN-MADE SEMICONDUCTOR BASED IMPLANT, THE DEVICE MOST LIKELY WILL DESTROY IT BUT YOU DON'T KNOW WHAT THE DESTROYED IMPLANT WILL CAUSE IN YOUR BODY. THIS IS ALSO THE WAY HOW YOU CAN DESTROY IMPLANTED CHIPS USED FOR IDENTIFICATION PURPOSES.
OR
IF YOU KNOW THE EXACT LOCATION OF THE IMPLANT, GET A “ZAPPER”, THAT USES AT LEAST 5000 VOLTS BUT MORE THE BETTER. I MODIFIED A TENNIS RACQUET TYPE BUG ZAPPER. WORKS PERFECTLY. PLACE THE ELECTRODES ACROSS WHERE THE IMPLANT IS AND ZAP THE AREA SEVERAL TIMES FROM DIFFERENT DIRECTIONS. IF YOU ARE AFRAID, IT WILL HURT AND SPARK ON YOUR SKIN, SO PRESS THE ELECTRODES HARD INTO YOUR SKIN. THE HIGH VOLTAGE FROM THE ELECTRODES WILL MAKE THE LOCAL MUSCLES MOVE. YOU CAN ALSO USE THIS “ZAPPER” ON BUG BITES AS THE HIGH VOLTAGE DESTABILIZES THE BUG POISON AND EVEN SNAKE POISON, SO YOUR IMMUNE SYSTEM CAN CLEAN IT UP. YOU HAVE TO “ZAP” THE AREA AND SURROUNDING AREA MANY TIMES TO BREAK DOWN THE POISON'S CHEMICAL BONDS.

IF, you are familiar with electronics, you could also build a handheld “Magnetometer”. Prospectors use this device. Sometimes, you could see a horizontal “rod” under a helicopter. That is the sensing unit of the magnetometer as it is doing grid scan of the area.

They use a type of magnetic sensor (there are different types such as “flux gate” and more sensitive ones) on each end of the “rod”. As the “rod” is moved, each sensor detects the magnetic flux lines of the Earth. These two signals are fed into a “comparator” (differential amp) that compares the two signals and if they are not the same, it alerts you.

If the two signals are not the same, that is an indication that there is some kind of ferrous material in the vicinity, somewhere between or around the two ends of the “rod”.

Similarly, if you build a handheld magnetometer and scan your body with it, it WILL detect magnetic anomaly if present in the form of an implant. They are VERY sensitive.

IF, you believe, you are bombarded with some kind of electronic signal, you could get a metal screen and copper screen (if you can). Make up several miniature device described above and place them between the metal and copper screen. Again,make sure the rotating magnets or the electromagnets are as close to the screens as possible.

What does this setup accomplish?
The magnets will induce voltages in the copper screen and a swirling/rotating magnetic field in the iron screen. These magnetic and electromagnetic fields are STRONGER, than what is used against people and they will either reflect, deflect or absorb the bombarding signals.

IF, “scalar” waves are used against you, there is NO DEFENCE FOR IT, as it goes right through everything. If you die because of scalar waves, your body won't even decompose for at least a month as the scalar wave DESTROYS EVERYTHING that is in your body, not just you.
Link about the nature of scalar waves.
https://www.youtube.com/watch?v=tJKzfKwKSDM

If a reader doesn't mind, perhaps email this post to the girl who is in the first link of the post, so she could implement it in her life.

It is not easy to make a proper Faraday cage and it is VERY expensive. A metal garbage can is NOT a Faraday cage. You could also get some old lead acid batteries, take the lead plates out, melt them down and pound it into sheets and surround the cage with them lead sheets. Paint the sheets.

Some revealing links for ya. Interesting stuff revealed in this link.
https://www.youtube.com/watch?v=bb-bdHGBcUY

The status quo entities sure hate when somebody has knowledge of their electronic “arsenals” and how to neutralize them. “They” can have it, “you” can't. There is nothing like equality and fair play in status quo world.
https://www.youtube.com/watch?v=fxPfgISHU3E

http://www.tscm.com/